* bug#43879: Problem with graphical installer
@ 2020-10-09 10:00 Marinus Savoritias
2020-10-19 14:41 ` Miguel Ángel Arruga Vivas
0 siblings, 1 reply; 3+ messages in thread
From: Marinus Savoritias @ 2020-10-09 10:00 UTC (permalink / raw)
To: 43879
If you follow the guided graphical install guix will fail to reconfigure
afterwards.
Everytime you will reconfigure it will say no space left on device. On
/boot.
the command to reconfigure i runed was: sudo guix system reconfigure
/etc/config.scm
Even if it is a new installation. I tried to format the disk seperately
and then install Guix but the same thing happen.
The only way to work around this bug if you use the graphical install,
is to choose manually partition the disk at the partition step of the
installer.
This bug was reproducible everytime in my machine with the latest iso
yesterday.
iso code: GUIX_i686-LINUX_024B273
Marinus Savoritias
^ permalink raw reply [flat|nested] 3+ messages in thread
* bug#43879: Problem with graphical installer
2020-10-09 10:00 bug#43879: Problem with graphical installer Marinus Savoritias
@ 2020-10-19 14:41 ` Miguel Ángel Arruga Vivas
2020-10-19 19:18 ` Marinus Savoritias
0 siblings, 1 reply; 3+ messages in thread
From: Miguel Ángel Arruga Vivas @ 2020-10-19 14:41 UTC (permalink / raw)
To: Marinus Savoritias; +Cc: 43879
Hi Marinius,
Marinus Savoritias <marinus.savoritias@disroot.org> writes:
> If you follow the guided graphical install guix will fail to
> reconfigure afterwards.
>
> Everytime you will reconfigure it will say no space left on device. On
> /boot.
The default installation should not create a separate /boot partition,
only creates /boot/efi for EFI installations when it cannot be already
found.
Could you provide the partition map you had when the error happened? A
simple df -h would do the trick.
Also, could you confirm the bootloader you were using (grub,
grub-efi...)?
Best regards,
Miguel
^ permalink raw reply [flat|nested] 3+ messages in thread
* bug#43879: Problem with graphical installer
2020-10-19 14:41 ` Miguel Ángel Arruga Vivas
@ 2020-10-19 19:18 ` Marinus Savoritias
0 siblings, 0 replies; 3+ messages in thread
From: Marinus Savoritias @ 2020-10-19 19:18 UTC (permalink / raw)
To: Miguel Ángel Arruga Vivas; +Cc: 43879
Hi,
The steps that I followed were:
1. Use guided installation using full disk with graphical installer
2. I selected use entire disk and not a separate /home
3. It gave me the warning that its going to format the disk.
At that point it formatted and I rebooted into the new system. There
were two partitions there.
One /boot/efi and one root (/). Every time I tried to reconfigure it
always ended with /boot not having enough space. At that point I went
into the /boot partition to check what are the files. I curiously found
that the files from the previous installation of Gentoo were there. Even
though the installer said that it formatted the disk.
I was using the default that the guided installation uses. I didn't
change anything there.
At that point as I said I formatted the disk separately to make sure it
was properly formatted this time but the same thing happened.
The only way I could work around the bug was by selecting the manual
partitioning instead of guided in the graphical installer.
Regards,
Marinus Savoritias
On 10/19/20 4:41 PM, Miguel Ángel Arruga Vivas wrote:
> Hi Marinius,
>
> Marinus Savoritias <marinus.savoritias@disroot.org> writes:
>> If you follow the guided graphical install guix will fail to
>> reconfigure afterwards.
>>
>> Everytime you will reconfigure it will say no space left on device. On
>> /boot.
> The default installation should not create a separate /boot partition,
> only creates /boot/efi for EFI installations when it cannot be already
> found.
>
> Could you provide the partition map you had when the error happened? A
> simple df -h would do the trick.
>
> Also, could you confirm the bootloader you were using (grub,
> grub-efi...)?
>
> Best regards,
> Miguel
^ permalink raw reply [flat|nested] 3+ messages in thread
end of thread, other threads:[~2020-10-19 19:19 UTC | newest]
Thread overview: 3+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2020-10-09 10:00 bug#43879: Problem with graphical installer Marinus Savoritias
2020-10-19 14:41 ` Miguel Ángel Arruga Vivas
2020-10-19 19:18 ` Marinus Savoritias
Code repositories for project(s) associated with this public inbox
https://git.savannah.gnu.org/cgit/guix.git
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for read-only IMAP folder(s) and NNTP newsgroup(s).