Very similar, When I use 'label instead, guix system reconfigure can work,

but the new system can not boot properly:

-------------------------
...
[   13.655133] input: HDA Intel MID Mic as /devices/pci0000:00/0000:00:1b.0/sound/card0/input18
[   13.655341] input: HDA Intel MID Headphone as /devices/pci0000:00/0000:00:1b.0/sound/card0/input19
[   13.655687] input: HDA ATI HDMI HDMI/DP,pcm=3 as /devices/pci0000:00/0000:00:01.0/0000:01:00.1/sound/card1/input17
[   13.787240] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'
[   13.787701] ieee80211 phy0: Atheros AR9285 Rev:2 mem=0xf85f0000, irq=19
[   13.797651] ath9k 0000:44:00.0 wlo1: renamed from wlan0
[   25.002086] NET: Registered protocol family 4
[   25.050341] NET: Registered protocol family 3
[   25.108242] NET: Registered protocol family 5
[   25.502868] IPv6: ADDRCONF(NETDEV_UP): wlo1: link is not ready

*** do nothing, and i have to reboot ****
------------------------

Before reconfigure, i will be like the below, I don't know the reason and how to debug :-(
--------------------------------
[   25.002086] NET: Registered protocol family 4
[   25.050341] NET: Registered protocol family 3
[   25.108242] NET: Registered protocol family 5
[   25.502868] IPv6: ADDRCONF(NETDEV_UP): wlo1: link is not ready
[            ] Service term-tty6 has been started.
[            ] Service term-tty5 has been started.
[            ] Service term-tty4 has been started.
[            ] Service term-tty3 has been started.
...
---------------------------------

>
>This very likely an instance of <https://bugs.gnu.org/23697>.  I’ll see
>if I can fix it soonish if nobody beats me at it.
>
>Thanks for your report!
>
>Ludo’.