Thanks for getting back to us. Closing then. Enjoy your new guix :) On May 5, 2022 11:54:15 PM GMT+02:00, Nathan Wilcox wrote: >It completed successfully. > >On Tue, May 3, 2022 at 10:27 PM Julien Lepiller wrote: > >> Hi Nathan, >> >> I believe this was caused by a network issue (&nar-error). We lost our >> main server for a few hours when you tried running guix pull. >> >> Could you try again and report success/failure? >> >> Thanks for reporting the issue! It's much appreciated :) >> >> On May 3, 2022 9:44:19 PM GMT+02:00, Nathan Wilcox via Bug reports for GNU >> Guix wrote: >>> >>> Hi, >>> >>> I just started using guix and have only used `guix pull` and `guix >>> search` so far. I used `guix pull` successfully a few days ago, and decided >>> to rerun it today to see if it takes less time, and it resulted in a >>> stacktrace (attached). >>> >>> This is a foreign-distro install on Debian 10 Buster. It's running inside >>> a 'crostini' lxc vm built into ChromeOS. >>> >>> Also, while I'm here, I read about `guix shell` and it was the primary >>> motivation for me to install since I wanted to do a project-specific >>> dependency configuration, but after following the instructions in [1] >>> running `guix shell` says `guix: shell: command not found`. I have tried >>> `guix search` with various patterns (`shell`, `guix.*shell`, etc…) but I >>> haven't been able to find out how to install it. Furthermore [1] introduces >>> it, so I am confused if I missed some critical setup step, even though I >>> followed the install section. Any advice? >>> >>> links: >>> [1] https://guix.gnu.org/manual/devel/en/html_node/Installation.html >>> >>> -- >>> >>> Nathan Wilcox >>> >>> Chief Research Officer >>> >>> nathan@electriccoin.co | @least_nathan >>> >>> >>> > >-- > >Nathan Wilcox > >Chief Research Officer > >nathan@electriccoin.co | @least_nathan