From: "Mitchell Wand" <wand@ccs.neu.edu>
To: "Scheme List" <scheme-announcements@lists.ccs.neu.edu>
Cc: Alan Bawden <scheme@bawden.org>, Guy Steele <Guy.Steele@sun.com>
Subject: [Scheme Steering Committee announcements] Scheme Language Steering Committee election: comment period is open
Date: Fri, 24 Oct 2008 11:28:21 -0400 [thread overview]
Message-ID: <1bd18ad50810240828v1072f12l1861fa84dcea7845__40675.6415650763$1224862350$gmane$org@mail.gmail.com> (raw)
[-- Attachment #1.1: Type: text/plain, Size: 9157 bytes --]
==============================
Steering Committee Replacement
==============================
Introduction
------------
The current Scheme Language Steering Committee was appointed in
January, 2004. We have seen the Scheme Standardization process, as
envisioned in the charter from November, 2003, through to the ratification
of the R6RS in 2007.
We believe that the R6RS is not the end of the Scheme language
standardization process, and that the Scheme language must continue to
evolve.
However, it was never our intention to be "Scheme Czars for Life." It is
time to turn the process over to other hands, so that the Scheme
language will remain alive and healthy for years to come.
It is therefore the intention of the Steering Committee to hold an
election to replace its members.
The Scheme Standardization Charter says, "The Steering Committee
itself shall establish procedures for replacing its members." This
document describes how the Steering Committee proposes to hold an
election to replace itself.
A copy of this announcement may be found at
http://www.r6rs.org/steering-committee/announcement-long.txt .
Comment Period
--------------
There will be a comment period of four weeks, during which anyone may
make comments or suggestions on the voting procedure described herein.
Comments should be sent to the r6rs-discuss@r6rs.org mailing list.
THE COMMENT PERIOD IS OPEN IMMEDIATELY (AS OF FRIDAY, 10/24/08), AND
WILL EXTEND FOR FOUR WEEKS, UNTIL FRIDAY, 11/21/08.
General Parameters
------------------
This -will- be a secret ballot.
In order to make it more difficult for any particular faction to gain
control of all three seats, we will be using a form of single transferable
vote proportional representation. Each voter will rank the candidates, and
an algorithm will compute a three-member committee that tries to fairly
represent the electorate.
Note that we will -not- be using the S-expression-based voting system we
used for the ratification vote. That system proved to be more trouble --
and less fun -- than the Steering Committee had hoped.
Voter Registration
------------------
Anybody who has a stake in the Scheme standards process -- except the
members of the Steering Committee -- may participate in the vote.
Everyone who registered for the ratification vote is automatically
registered for this vote. We will re-verify all the email addresses on
this list. Any voters whose addresses have changed should contact
voter-registration@r6rs.org to request a change-of-address.
People who did not register for the ratification vote may register to vote
for the new Steering Committee by suppling a "Statement of Interest"
declaring what their stake is in the Scheme standardization process. Each
voter's statement must be original, must be at least 75 words long, and
must actually address the question of what the voter's interest is in the
process. At the end of the registration period (but before any voting),
the list of enrolled voters will be published along with their statements
of interest.
Here are the voter instructions for the registration process:
Download the registration form from [URL to be supplied]. The
registration form asks for the following information:
1. Email Address
2. Full Name
3. Geographic Location (country, region, city, etc.)
4. Affiliation (optional)
5. Public Email Address (optional)
6. Web Page URL (optional)
7. Statement of Interest
The email address supplied in item 1 will be used for all future
correspondence with you, but will not be published. The rest of the
form will be made public. Items 2 through 6 are for identification
purposes only. (The email address in item 5 is optional as spammers
will inevitably collect any address supplied here.)
The completed form should be mailed to "voter-registration@r6rs.org".
We will perform a standard address confirmation on the email address you
supply in item 1. (i.e., we will use it to mail you something that you
have to mail back in order to prove that the person at that address
really wants to vote on the future of Scheme.)
Your Statement of Interest must be original, it must be at least 75
words long, and it must actually address the question of what your
interest is in the Scheme standardization process. Be aware that we
will read your statement, and if we think you have seriously missed the
mark, we will ask you to submit another one. It is not our intent to
run an essay competition here, we are just looking for evidence that
you're taking this seriously.
Voter Registration Closes
-------------------------
The registration period will end at least four weeks after it starts.
When the registration period ends, the complete list of enrolled voters
will be published on www.r6rs.org. This voter roll will include all of the
registration forms. This publication will be advertised to the public.
Voters should check that their own information appears on the voter roll as
they expected. Any irregularities (missing entries, fraudulent entries,
duplicate or plagiarized statements, etc.) should be brought to the
attention of the Steering Committee, who will take appropriate action.
Nominations
-----------
The nomination period will start and end at the same times as the
registration period.
Anybody can nominate anybody. Nominators do not have to be registered
voters. Nominees do not have to be registered voters. People can nominate
themselves.
Nominations should be sent to sc-nomination@r6rs.org. Nominations must at
least include an email address for the nominee.
Nominees will be offered a chance to decline their nomination. If
they accept their nomination, they will be asked for additional
identifying information, similar to that used for registration, to
appear on the candidate list. Candidates will also be asked to supply
a statement of no more than 250 words about why they should be elected
to the Steering Committee.
When the nomination period ends, the complete list of candidates
will be published on www.r6rs.org.
Candidates may also post whatever messages they wish to
comp.lang.scheme, the r6rs-discuss mailing list, or whatever other
forums they feel appropriate, and voters should feel free to discuss
the candidates and their positions on these fora.
The Vote
--------
The voting period will begin one week after the registration and nomination
periods end.
Here are the voter instructions for the vote:
Download the ballot from [URL to be supplied]. The ballot asks for
the following information:
1. Email Address
2. An ordered list of one or more of the candidates.
The email address supplied in item 1 should match the address you
supplied in item 1 on your registration form.
Your completed ballot should be mailed to "new-sc-vote@r6rs.org".
We will mail you an acknowledgment when we have received your vote.
The poll will be open for two weeks.
Note that although we will not make your vote public, your vote *may*
be visible to the person or persons who open the voting email. (We
*may* create a bot to do this, but this may or may not happen and it may
or may not work well enough to trust without manual confirmation.)
The Result
----------
The ballots will be counted using a form of single transferable vote
proportional representation. The basics of this system are reasonably well
described (at the time this was written) at
<http://en.wikipedia.org/wiki/Single_transferable_vote>. The actual code
that will be used to perform this process can be found at
<http://www.r6rs.org/steering-committee/pr.scm>. This code is written in
basic Scheme, and extensively commented -- any questions you may have about
the precise details of the procedure can best be answered by reading the
code.
Should a tie-breaker be necessary, the random selection will be performed
by using some physical source of randomness (coins, dice, etc.). This
event will take place at a pre-announced time and location, and witnesses
will be welcome to observe.
In order to allow for a tie-breaker or any irregularities to be dealt with,
the official result will not be officially announced until two weeks after
the poll closes.
Exceptional Cases
-----------------
The Steering Committee may remove anyone from the list of enrolled voters,
remove anyone from the list of candidates, reject any vote, or otherwise
make exceptions to the process described herein, if they believe an attempt
has been made to cheat, or if some other unexpected circumstance has
arisen. The Steering Committee will not take such actions capriciously,
and they will endeavor to be as fair as possible.
Sample Schedule
---------------
0. Comment period starts on 18 October 1008.
1. Voter registration and nominations start: 12:00 GMT on 15 November
2008.
2. Voter registration and nominations end: 12:00 GMT on 13 December 2008.
3. Voting starts: 12:00 GMT on 19 December 2008.
4. Voting ends: 12:00 GMT on 3 January 2009.
5. Official results announced: 17 January 2009.
[-- Attachment #1.2: Type: text/html, Size: 11278 bytes --]
[-- Attachment #2: Type: text/plain, Size: 181 bytes --]
_______________________________________________
Scheme-announcements mailing list
Scheme-announcements@lists.ccs.neu.edu
https://lists.ccs.neu.edu/bin/listinfo/scheme-announcements
reply other threads:[~2008-10-24 15:28 UTC|newest]
Thread overview: [no followups] expand[flat|nested] mbox.gz Atom feed
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
List information: https://www.gnu.org/software/guile/
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to='1bd18ad50810240828v1072f12l1861fa84dcea7845__40675.6415650763$1224862350$gmane$org@mail.gmail.com' \
--to=wand@ccs.neu.edu \
--cc=Guy.Steele@sun.com \
--cc=scheme-announcements@lists.ccs.neu.edu \
--cc=scheme@bawden.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for read-only IMAP folder(s) and NNTP newsgroup(s).