Re: Comments in assembly-mode and tabstops

[Kevin Rodgers <kevin.d.rodgers@gmail.com>]

On 1/2/11 8:19 AM, Mark Tilford wrote:
> 1)  If I want to comment out a few lines of assembly, I tend to:
> - Move the cursor to the beginning of the line.
> - Push semicolon
>
> Unfortunately, emacs decides to jump to the end of the line (or worse,
> sometimes the middle of the line) before putting down the semicolon.
> I have to use the method of:
> - Move the cursor to the beginning of the line
> - Push enter
> - Push up
> - Push semicolon
> - Push delete
>
> This is very annoying.  What's the intended way to comment out code in
> assembly-mode (or disable the above behavior)?

Isn't it the same as all modes? i.e. mark the beginning of the first line,
move down, and type M-;

> 2)  I like a two or four space indention on my code.  Unfortunately,
> emacs tends to store this as a mix of tabs and spaces.
> Is there a way to have emacs handle the combination of, say, a four
> space indent and three levels deep stored as three tab characters, and
> displayed with the width of 12 spaces?
>
> 3)  I'm really used to the behavior of "If a line is wider than the
> window, down arrowing only stops once on that line."  Is there a way
> to get this behavior back?

-- 
Kevin Rodgers
Denver, Colorado, USA