Re: Export width for generated SVG image?

[John Hendy <jw.hendy@gmail.com>]

On Tue, Mar 26, 2013 at 3:16 PM, Ken Williams
<Ken.Williams@windlogics.com> wrote:
> I’m using a ‘dot’ section to create an SVG image, then exporting my document
> to HTML:

[deleted]

> My diagram ends up pretty huge though, and I want to shrink it down.
> ":width 1000" doesn’t seem to have any effect, nor does wrapping like so:

[deleted]

> Any suggestions?

This works for me on version 8.0-pre

#+attr_html: :width 100%
[[image.svg]]

Are you using the new exporter or old? I believe the old syntax would have been:

#+attr_html width="100%"
[[image.svg]]

But try with and without quotes (I can't check for the old exporter
syntax on my setup anymore... well, I /could/ but that's a lot of
work!).


John

>
> I’m using version 7.9.2-dist .  Thanks.
>
>
>
> --
>
> Ken Williams, Senior Research Scientist
>
> WindLogics
>
> http://windlogics.com
>
>
>
>
> ________________________________
>
> CONFIDENTIALITY NOTICE: This e-mail message is for the sole use of the
> intended recipient(s) and may contain confidential and privileged
> information. Any unauthorized review, use, disclosure or distribution of any
> kind is strictly prohibited. If you are not the intended recipient, please
> contact the sender via reply e-mail and destroy all copies of the original
> message. Thank you.