Re: [Question] use-package's :init or :config for enabling modes

[Ergus <spacibba@aol.com>]

Hi:

I am not specialist here, but they exist because the :init is ALWAYS
executed while loading the init.el, but the :config is executed AFTER
loading the package (using eval-after-load).

In your example the package is loaded immediately-unconditionally
because there is not defer, so, you don't see any difference; but if
some package is loaded lazily you will see the difference.

When we defer the load (either with the :defer, :command or :keys) the
package is lazily loaded using the autoload mecanisms.

#+BEGIN_SRC elisp
(use-package vertico :defer t
   :init
   (message "Call 1") ;; this will execute always
   :config
   (message "Call 2") ;; this will execute after M-x vertico-mode
   (vertico-mode 1))
#+END_SRC

Hope this helps,
Ergus

On Sun, May 19, 2024 at 12:38:02PM GMT, Rodrigo Morales wrote:
>
>I emptied =~/.config/emacs/init.el= file and I inserted the following sexp and launched Emacs. =vertico-mode= was enabled.
>
>#+BEGIN_SRC elisp
>(use-package vertico
>
>  :config (vertico-mode))
>#+END_SRC
>
>I emptied =~/.config/emacs/init.el= again and I inserted the following sexp and launched Emacs. =vertico-mode= was enabled.
>
>#+BEGIN_SRC elisp
>(use-package vertico
>
>  :init (vertico-mode))
>#+END_SRC
>
>As shown above, whether we use =:init= or =:config= both can be used for enabling a mode. So my question is: What's the difference between using =:config= and =:init= for enabling a mode that is defined by a package.
>
>* System information
>
>GNU Emacs 29.3 (build 1, x86_64-pc-linux-gnu, GTK+ Version 3.24.41, cairo version 1.18.0)
>