Sorry, I tried the tutorial01, it failed withn not found the libgccjit library, then I tried to install the library with homebrew, whig said it was there, the I god into that a reintall loader the X86 instad of the ARM for my M1 iMac, so indtil futher, I give up, and will not attemp to compile 28.0.50 and just run on 27.2….. mvh Niels > Den 3. jun. 2021 kl. 10.12 skrev Andrea Corallo : > > Eli Zaretskii > writes: > >>> From: Niels Søndergaard >>> Date: Thu, 3 Jun 2021 08:51:06 +0200 >>> Cc: Niels Søndergaard , >>> 48804@debbugs.gnu.org >>> >>> The configure sends a link, but I can’t find the source to compile out of that, neither can I understand, what >>> the “smoke” test is. >> >> The link shows a source of a C program whose first line says: >> >> Smoketest example for libgccjit.so >> >>> I tried to follow the instruktions, but god lost underway…. >> >> You mean, the instructions on the URL how to compile the test program? >> They are quite simple: 2 shell commands. >> >> Anyway, I've modified that error message to say this instead: >> >> The installed libgccjit failed to compile and run a test program using >> the libgccjit library; see config.log for the details of the failure. >> The test program can be found here: >> . > > Just a small note, the smoke test we run from the configure is not > exactly the one of the link as we just compile a function returning an > integer. Needless to say that most certainly if one works the other > will too. > > Andrea